Taylor C300 NP, Operator'S Manual

USER INTERFACE

5-7 

Model C300

User Interface 

 5

Screen I—SERVICE MENU

This screen allows the authorized service technician to 

access service information. Press the MENU (SEL) key 

to return to the OPERATOR MENU.

Syrup Out Indicator

If the word OUT appears in one of the columns next to 

the word SYRUP, it indicates a lack of syrup or syrup 

pressure being supplied for the indicated freezing 

cylinder. f the unit is in the AUTO or PRIME modes, the 

product light will illuminate and a warning tone will sound 

for that freezing cylinder. At this time, replace the 

appropriate bag-in-the-box. As a safety feature, the 

refrigeration system automatically stops to prevent a 

freeze-up in the freezing cylinder.

If a syrup out condition occurs on one side, that side will 

enter the HOLD mode at which time refrigeration remains 

off, the beater continues to run, and the CO

2

 solenoid is 

closed for that side to prevent the dispensing of product. 

The opposite side will not be affected.

CO

2 

Out Indicator

On the LCD, if the word OUT appears next to CO

2,

 it 

indicates a lack of CO

2

 being supplied to the freezer. The 

product light will also illuminate, and a warning tone will 

sound. This will continue until the CO

2

 is replaced. If the 

CO

2

 is not replaced within 1-minute, the machine will 

shut down and a fault message will appear.

Water Out Indicator

On the LCD, if the word OUT appears next to the word 

WATER, it indicates a lack of water being supplied to the 

freezer. In addition, the product light will illuminate, and a 

warning tone will sound. This will continue until the 

proper amount of water is supplied to the freezer. If the 

water is not supplied within 1-minute, the machine will 

shut down and a fault message will appear.

Audio Alarm Silencer

The audio alarm will be disabled if the ALARM SILENCE 

key is pressed. If a new fault or fault condition occurs or 

the system mode changes, the audio alarm will be 



re-enabled automatically. If the audio alarm is silenced 

for greater than 30-minutes without correcting the fault, it 

will be re-enabled automatically.

Product Light

When the light is continuously lit (not flashing) it indicates 

that there is an OUT condition for syrup, water, or CO

2

.

When the light is flashing, it indicates that the product is 

not at serving viscosity. This will occur during the initial 

freeze down, a defrost cycle, a FAULT condition, and 

power saver modes.

Sampling Valve

The sampling valve is located behind the lower front 

panel. The sampling valve is used to obtain a brix 

reading.

Daily Procedures

The following procedure should be performed 

daily

.

Remove the splash shield and front drip tray. Take these 

parts to the sink and brush-clean them. Re-install the 

parts onto the freezer. Use a clean, sanitized towel and 

wipe down the front of the machine, including the doors 

and spouts.

OPERATOR MENU

A B C D E F G H I

SERVICE MENU

L

E

S

>

-

-

-

-

<

AUTO

MODE

AUTO

OUT

SYRUP

OK

K

O

-

R

E

T

A

W

K

O

-

2

O

C

AUTO

MODE

AUTO

OK

SYRUP

OK

K

O

-

R

E

T

A

W

T

U

O

-

2

O

C

AUTO

MODE

AUTO

OK

SYRUP

OK

T

U

O

-

R

E

T

A

W

K

O

-

2

O

C