Section 2
2-1
Model C300
To the Operator
2
To the Operator
The freezer you have purchased has been carefully
engineered and manufactured to give you dependable
operation.
The Model C300, when properly operated and cared for,
will produce a consistent quality product. Like all
mechanical products, this machine will require cleaning
and scheduled maintenance. A minimum amount of care
and attention is necessary if the operating procedures
outlined in this manual are followed closely.
IMPORTANT!
This manual should be read
before operating or performing any maintenance on the
machine.
Your Taylor machine will
NOT
compensate for and/or
correct any errors made during the setup or filling
operations. Thus, the initial assembly, setup, and priming
procedures are of extreme importance. It is strongly
recommended that all personnel responsible for the
machine's operation, including assembly and
disassembly, go through these procedures together in
order to be properly trained and to make sure that all
personnel understand their role in using and maintaining
the unit.
In the event you should require technical assistance,
please contact your local authorized Taylor distributor.
Note:
Your Taylor warranty is valid only if the parts are
authorized Taylor parts, purchased from the local
authorized Taylor distributor, and only if all required
service work is provided by an authorized Taylor service
technician. Taylor reserves the right to deny warranty
claims on units or parts if non-Taylor approved parts or
incorrect refrigerant were installed in the unit, system
modifications were performed beyond factory
recommendations, or it is determined that the failure was
caused by abuse, misuse, neglect, or failure to follow all
operating instructions. For full details of your Taylor
warranty, please see the Limited Warranty section in this
manual.
Note:
Constant research results in steady
improvements; therefore, information in this manual is
subject to change without notice.
IMPORTANT!
If the crossed-out wheeled-bin
symbol is affixed to this
machine
, it signifies that this
machine is compliant with the EU Directives as well as
other similar end-of-life legislation in effect after August
13, 2005. Therefore, it must be collected separately after
its use is completed and cannot be disposed as unsorted
municipal waste.
The user is responsible for returning the machine to the
appropriate collection facility, as specified by your local
code.
For additional information regarding applicable local
disposal laws, please contact the municipal waste facility
and/or local authorized Taylor distributor.
Summary of Contents for C300 NP
