18
Model C300
Operating Procedures
090417
Section 6
Operating Procedures
The Model C300 contains two 7 quart (6.6 liter)
freezing cylinders.
CAUTION: This unit is pressurized when
in operation.
The control switch must be in the OFF
position until the unit is completely assembled. No
part should ever be removed from the machine while
it is in operation. No parts should be removed until
the control switch has been turned to the OFF
position and all pressure has been relieved by
opening the draw valve. Failure to follow this
instruction may result in severe personal injury from
hazardous moving parts or from the impact of
propelled parts.
The syrup flow control combines the two ingredients
of water and syrup, and sends this combination to
the freezing cylinder. As product is drawn, new
product will flow from the flow control into the
freezing cylinder. CO
2
is supplied after the flow
control to carbonate the product and aid in
dispensing.
We begin our instructions at the point where the
parts are disassembled and laid out to air dry.
The following procedures will show you how to
assemble the parts into the freezer, sanitize them,
and prime the freezer with fresh product.
Duplicate the following procedures, where they
apply, for the other freezing cylinder.
If you are disassembling the machine for the first
time or need information to get to this starting point
in our instructions, turn to page 29 , “Disassembly”
and start there.
Assembly
MAKE SURE THE CONTROL SWITCH IS
IN THE “OFF” POSITION. Failure to do so may
result in personal injury or component damage.
Note:
When lubricating parts, use an approved food
grade lubricant (example: Taylor Lube HP).
Step 1
Lubricate the o--ring groove. Slide the o--ring into the
groove on the drive shaft. Lubricate the drive shaft
seal groove, the o--ring, and the shaft portion that
comes in contact with the bearing on the beater
drive shaft.
DO NOT
lubricate the hex end of the
drive shaft.
Figure 6
Summary of Contents for C300 NP
Page 51: ...Model C300 059540 27 4 11...
Page 52: ...Model C300 059540 33 4 11...
Page 53: ...Model C300 059540 40 4 11...
Page 54: ...Model C300 059540 58 4 11...
