Section 3
3-1
Model C303 & C314
Safety
3
Safety
We at Taylor Company are concerned about the safety of
the operator when he or she comes in contact with the
freezer and its parts. Taylor has gone to extreme efforts
to design and manufacture built-in safety features to
protect both you and the service technician. As an
example, warning labels have been attached to the
freezer to further point out safety precautions to the
operator.
IMPORTANT!
Failure to adhere to the
following safety precautions may result in severe
personal injury. Failure to comply with these warnings
may damage the machine and its components.
Component damage will result in part replacement
expense and service repair expense test
.
NOTICE! DO NOT
operate the freezer without
reading the Operator’s Manual. Failure to follow this
instruction may result in equipment damage, poor freezer
performance, health hazards, or personal injury.
IMPORTANT!
This machine is to be used only
by trained personnel. It is not intended for use by children
or people with reduced physical, sensory, or mental
capabilities, or lack of experience and knowledge, unless
given supervision or instruction concerning the use of the
machine by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
IMPORTANT!
This unit is provided with an
equipotential grounding lug that is to be properly
attached to the rear of the frame by the authorized
installer. The installation location is marked by the
equipotential bonding symbol (5021 of IEC 60417- 1) on
the removable panel and the frame.
WARNING! DO NOT
use a water jet to clean
or rinse the freezer. Failure to follow these instructions
may result in serious electrical shock.
WARNING!
Avoid injury.
•
DO NOT
operate the freezer unless it is properly
grounded.
•
DO NOT
operate freezer with larger fuses than
specified on the data label.
•
All repairs must be performed by an authorized
Taylor service technician.
•
The main power supplies to machine must be
disconnected prior to performing repairs.
•
For Cord-Connected Units:
Only authorized
Taylor service technicians or licensed
electricians may install a plug or replacement
cord on the unit.
•
Stationary machines which are not equipped
with a power cord and a plug or another device
to disconnect the machine from the power
source must have an all-pole disconnecting
device with a contact gap of at least 0.125 in.
(3 mm) installed in the external installation.
•
Machines that are permanently connected to
fixed wiring and for which leakage currents may
exceed 10 mA, particularly when disconnected
or not used for long periods, or during initial
installation, shall have protective devices to
protect against the leakage of current, such as a
GFI, installed by the authorized personnel to the
local codes.
•
Supply cords used with this unit shall be oil-
resistant, sheathed flexible cable not lighter
!
!
Summary of Contents for C303
