3-2
SAFETY
Model C303 & C314
Safety
3
than ordinary polychloroprene or other
equivalent synthetic elastomer-sheathed cord
(code designation 60245 IEC 57) installed with
the proper cord anchorage to relieve conductors
from strain, including twisting, at the terminals
and protect the insulation of the conductors
from abrasion.
•
If the supply cord is damaged, it must be
replaced by the manufacturer, service agent, or
a similarly qualified person, in order to avoid a
hazard.
Failure to follow these instructions may result in
electrocution. Contact your local authorized Taylor
distributor for service.
WARNING!
Avoid injury.
•
DO NOT
allow untrained personnel to operate
this machine.
•
DO NOT
put objects or fingers in door spout.
•
DO NOT
operate the freezer unless all service
panels and access doors are fastened with
screws.
•
DO NOT
remove the freezer door or beater
assembly unless the control switches are in the
OFF position.
Failure to follow these instructions may result in severe
personal injury from hazardous moving parts.
This unit has many sharp edges that can
cause severe injuries.
•
DO NOT
put objects or fingers in the door
spout. This may contaminate the product and
cause severe personal injury from blade
contact.
•
USE EXTREME CAUTION
when removing the
beater assembly. The scraper blades are very
sharp.
WARNING!
This unit is pressurized when in
operation.
•
The control switch must be in the OFF position
until the unit is completely assembled.
•
No part should ever be removed from the
machine while it is in operation.
•
No parts should be removed until the control
switch has been turned to the OFF position and
all pressure has been relieved by opening the
draw valve.
Failure to follow this instruction may result in severe
personal injury from hazardous moving parts or from the
impact of propelled parts.
IMPORTANT!
Access to the service area of
the unit is restricted to persons having knowledge and
practical experience with the appliance, in particular as
far as safety and hygiene are concerned.
CAUTION!
This unit must be installed on a
level surface to avoid the hazard of tipping. Extreme care
should be taken in moving this equipment for any reason.
Two or more persons are required to safely move this
unit. Failure to comply may result in personal injury or
equipment damage.
NOTICE!
Cleaning and sanitizing schedules
are governed by your federal, state, or local regulatory
agencies and must be followed accordingly. Please see
the cleaning section of this manual for the proper
procedure to clean this unit.
CAUTION!
This machine is designed to
!
!
!
Summary of Contents for C303
