OPERATING PROCEDURES
6-3
Model C303 & C314
Operating Procedures
6
7.
Align the flats on the end of the beater assembly with
the drive shaft. Make sure the beater assembly
locating pin is in position in the locating hole of the
drive shaft. Turn the beater slightly to be certain that
the beater is properly seated. When in position, the
beater will be approximately 3/8" inside the front of
the freezing cylinder.
Important!
Failure to properly seat the beater may cause
damage to the beater and the door.
Figure 6-7
Note:
The scraper blades on the beater assembly
should be in the 6 and 12 o'clock positions. This will
enable freezer door installation.
Figure 6-8
8.
Before installing the draw valve, slide the two o-rings
into the grooves on the draw valve. Lubricate the O-
rings and the valve as illustrated below.
Figure 6-9
9. Insert the draw valve into the freezer door spout from
the front of the unit. The valve is properly installed
when the hole in the draw valve is visible in the slot of
the freezer door spout.
Figure 6-10
10. Snap the draw valve handle onto the door spout.
Align the hole in the draw valve with the slot in the
draw handle.
Figure 6-11
11127
11128
Summary of Contents for C303
