OPERATING PROCEDURES
6-3
Model C612
Operating Procedures
6
10. Place the freezer door O-ring into the groove on the
back of the freezer door. Lubricate the outside
diameter of the front bearing. Slide the front bearing
into the door hub.
Note:
If necessary, put two small spots of lubricant at
the 10 o'clock and 2 o'clock positions on the freezer door
O-ring to keep it in place.
Figure 6-9
11. Install the shake freezer door. Position the freezer
door on the four studs on the front of the freezing
cylinder with the door seated fully. Install the
handscrews. Tighten equally in a crisscross pattern
to ensure the door is secured.
Figure 6-10
12. Install the draw handle. Secure it with the pivot pin.
Figure 6-11
Freezing Cylinder Assembly—Soft Serve Side
WARNING!
Make sure the power switch is in
the OFF position. Failure to follow this instruction may
result in severe personal injury from hazardous moving
parts.
Set up using the parts tray for the soft serve side.
1. Lubricate the groove on the soft serve beater
driveshaft before installing. Slide the beater
driveshaft boot seal over the small end of the beater
driveshaft and engage into the groove on the shaft.
Heavily lubricate the inside portion of the boot seal
and lubricate the flat end of the boot seal that comes
in contact with the rear shell bearing. Apply an even
coat of lubricant to the shaft.
Do not
lubricate the hex
end. (See Figure 6-12.)
Figure 6-12
Note:
When lubricating parts, use an approved
food-grade lubricant (example: Taylor Lube).
Note:
To ensure the mix does not leak from the back of
the freezing cylinder, the middle section of the boot seal
should be convex, or extend from the seal. If the middle
section of the boot seal is concave, or extending into the
middle of the seal, turn the seal inside out.
(See Figure 6-13
.
)
Summary of Contents for C612
Page 8: ...1 4 TO THE INSTALLER Model C612 To the Installer 1 Notes...
Page 54: ...9 2 PARTS REPLACEMENT SCHEDULE Model C612 Parts Replacement Schedule 9 Notes...
Page 58: ...10 4 LIMITED WARRANTY ON EQUIPMENT Model C612 Limited Warranty on Equipment 10 Notes...
Page 62: ...11 4 LIMITED WARRANTY ON PARTS Model C612 Limited Warranty on Parts 11 Notes...
