Taylor C706, Operator'S Manual

TO THE INSTALLER

1-3 

Model C706

To the Installer 

 1

IMPORTANT! 

This machine is provided with an 

equipotential grounding lug that is to be properly 

attached to the rear of the frame by the authorized 

installer. The installation location is marked by the 

equipotential bonding symbol (5021 of IEC 60417-1) on 

both the removable panel and the machine’s frame.

Stationary machines which are not equipped with a 

power cord and a plug or other device to disconnect the 

machine from the power source must have an all-pole 

disconnecting device with a contact gap of at least 



0.125 in. (3 mm) installed in the external installation.

Machines that are permanently connected to fixed wiring 

and for which leakage currents may exceed 10 mA, 

particularly when disconnected or not used for long 

periods, or during initial installation, shall have protective 

devices to protect against the leakage of current, such as 

a GFI, installed by the authorized personnel to the local 

codes.

Supply cords used with this machine shall be oil-

resistant, sheathed flexible cable not lighter than ordinary 

polychloroprene or other equivalent synthetic elastomer-

sheathed cord (code designation 60245 IEC 57) installed 

with the proper cord anchorage to relieve conductors 

from strain, including twisting, at the terminals and 

protect the insulation of the conductors from abrasion.

Beater Rotation

NOTICE! 

Beater rotation must be clockwise as 

viewed looking into the freezing cylinder.

To correct the rotation on a three-phase machine, 

interchange any two incoming power supply lines at the 

freezer main terminal block only. To correct rotation on a 

single-phase machine, exchange leads inside the beater 

motor. (Follow the diagram printed on the motor.)

Electrical connections are made directly to the terminal 

block provided in the main control box located behind the 

service panel.

It is recommended that beater rotation adjustment be 

performed by an authorized Taylor service technician.

Refrigerant

CAUTION!

 This machine contains fluorinated 

greenhouse gases (F-Gas) to provide refrigeration using 

a hermetically sealed circuit or within foam insulation. 

This machine’s type of gas, quantity, Global Warming 

Potential (GWP) and CO

2

 tonnes equivalent information 

is recorded on the machine’s data label. The refrigerant 

used is generally considered nontoxic and 

nonflammable. However any gas under pressure is 

potentially hazardous and must be handled with caution. 

NEVER

 fill any refrigerant cylinder completely with liquid. 

Filling the cylinder to approximately 80% will allow for 

normal expansion.

CAUTION! 

Use only approved refrigerant 

listed on the machine's data label or authorized through a 

manufacturer's technical bulletin. The use of any other 

refrigerant may expose users and operators to 

unexpected safety hazards.

WARNING!

 Refrigerant liquid sprayed onto the 

skin may cause serious damage to tissue. Keep eyes 

and skin protected. If refrigerant burns should occur, 

flush the area immediately with cold water. If burns are 

severe, apply ice packs and contact a physician 

immediately.

IMPORTANT!

 Refrigerants and their 

associated lubricants may be extremely moisture 

absorbent. When opening a refrigeration system, the 

maximum time the system is open must not exceed 15 

minutes. Cap all open tubing to prevent humid air or 

water from being absorbed by the oil.