3-2
SAFETY
Model C707
Safety
3
WARNING!
Avoid injury.
•
DO NOT
allow untrained personnel to operate
this machine.
•
DO NOT
operate the machine unless all service
panels and access doors are fastened with
screws.
•
DO NOT
remove any internal operating parts
(including, but not limited to the freezer door,
beater, or scraper blades) unless all control
switches are in the OFF position.
Failure to follow these instructions may result in severe
personal injury, especially to fingers or hands, from
hazardous moving parts.
WARNING!
This machine has many sharp
edges that can cause severe injuries.
•
DO NOT
put objects or fingers in the door
spout. This may contaminate the product and
cause severe personal injury from blade
contact.
•
USE EXTREME CAUTION
when removing the
beater assembly. The scraper blades are very
sharp.
•
USE EXTREME CAUTION
when handling the
cup/cone dispenser (if supplied with machine).
Two people are required to handle the cup/cone
dispenser. The appropriate type of protective
gloves must be worn and the mounting holes
must
NOT
be used to lift or hold the dispenser.
Failure to follow these instructions can result in personal
injury or damage to the machine.
IMPORTANT!
Access to the service area of
the machine is restricted to persons having knowledge
and practical experience with the appliance, as far as
safety and hygiene are concerned.
CAUTION!
This machine must be placed on a
level surface. Failure to comply may result in personal
injury or machine damage.
NOTICE!
Cleaning and sanitizing schedules
are governed by your federal, state, or local regulatory
agencies and must be followed accordingly. Please see
the cleaning section of this manual for the proper
procedure to clean this machine.
CAUTION!
This machine is designed to
maintain product temperature under 41°F (5
C). Any
product being added to this machine must be below 41
F
(5
C). Failure to follow this instruction may result in
health hazards and poor machine performance.
Do not
obstruct air intake and discharge openings:
The Model C707 air-cooled machine requires a minimum
of 6 in. (152 mm) of clearance on both sides and 0 in. in
the rear. This will allow for adequate airflow across the
condenser(s). Failure to allow adequate clearance can
reduce the refrigeration capacity and possibly cause
permanent damage to the compressor.
For Indoor Use Only:
This machine is designed to
operate indoors, under normal ambient temperatures of
70
º
F to 75
º
F (21
º
C to 24
º
C). The freezer has
successfully performed in high ambient temperatures of
104
º
F (40
º
C) at reduced capacities.
Do not
run the machine without product. Failure to follow
this instruction can result in damage to the machine.
Noise level:
Airborne noise emission does not exceed
78 dB(A) when measured at a distance of
1.0 meter from the surface of the machine and at a height
of 1.6 meters from the floor.
Summary of Contents for C707
Page 16: ...4 4 OPERATOR PARTS IDENTIFICATION Model C707 Operator Parts Identification 4 Notes ...
Page 36: ...9 2 PARTS REPLACEMENT SCHEDULE Model C707 Parts Replacement Schedule 9 Notes ...
Page 40: ...10 4 LIMITED WARRANTY ON MACHINES Model C707 Limited Warranty on Machines 10 Notes ...
Page 44: ...11 4 LIMITED WARRANTY ON PARTS Models C707 Limited Warranty on Parts 11 Notes ...