OPERATING PROCEDURES
6-5
Model C707
Operating Procedures
6
20. Install the air orifice into the hole in the top of the feed
tube (in the end without the small hole on the side).
Figure 6-14
21. Lay the feed tube (with the air orifice installed) and
the hopper gasket in the bottom of the mix hopper for
sanitizing.
22. Slide the rear drip pan into the hole in the side panel.
Figure 6-15
Sanitizing
1. Prepare an approved 100 ppm sanitizing solution
(examples: 2-1/2 gal. [9.5 L] of Kay-5® or 2 gal.
[7.6 L] of Stera-Sheen®). Use warm water and follow
the manufacturer’s specifications.
2. Pour the sanitizing solution over all the parts in the
bottom of the mix hopper and allow it to flow into the
freezing cylinder.
Figure 6-16
Note:
You have just sanitized the mix hopper and parts.
Make sure your hands are clean and sanitized before
proceeding.
3. While the solution is flowing into the freezing cylinder,
take particular care to brush-clean the mix level
sensing probe on the front wall and the bottom of the
hopper, the mix hopper, and the feed tube.
Figure 6-17
12078
17061
12029
12178
Summary of Contents for C707
Page 16: ...4 4 OPERATOR PARTS IDENTIFICATION Model C707 Operator Parts Identification 4 Notes ...
Page 36: ...9 2 PARTS REPLACEMENT SCHEDULE Model C707 Parts Replacement Schedule 9 Notes ...
Page 40: ...10 4 LIMITED WARRANTY ON MACHINES Model C707 Limited Warranty on Machines 10 Notes ...
Page 44: ...11 4 LIMITED WARRANTY ON PARTS Models C707 Limited Warranty on Parts 11 Notes ...