Section 2
2-1
Models C709 & C717
To the Operator
2
To the Operator
Your freezer has been carefully engineered and
manufactured to give you dependable operation. When
properly operated and cared for, it will produce a
consistent, quality product. Like all mechanical products,
cleaning and maintenance will be required. A minimum
amount of care and attention is necessary if the operating
procedures outlined in this manual are followed closely.
IMPORTANT!
This manual should be read
before operating or performing any maintenance on the
machine.
Your Taylor machine will
NOT
compensate for and/or
correct any errors made during setup or filling operations.
Thus, the initial assembly, setup, and priming procedures
are of extreme importance. It is strongly recommended
that all personnel responsible for the machine's
operation, including assembly and disassembly, go
through these procedures together to be properly trained
and to make sure that all personnel understand their role
in using and maintaining the machine.
If you require technical assistance, please contact your
local authorized Taylor distributor.
Note:
Your Taylor warranty is valid only if the parts are
authorized Taylor parts, purchased from the local
authorized Taylor distributor, and only if all required
service work is provided by a Taylor service technician.
Taylor reserves the right to deny warranty claims on
machines or parts if Taylor-unapproved parts or incorrect
refrigerant were installed in the machine, system
modifications were performed beyond factory
recommendations, or it is determined that the failure was
caused by abuse, misuse, neglect, or failure to follow all
operating instructions. For full details of your Taylor
warranty, see the Limited Warranty section in this
manual.
Note:
Constant research results in steady
improvements; therefore, information in this manual is
subject to change without notice.
For additional information regarding applicable local
laws, contact the municipal facility and/or local distributor.
IMPORTANT!
If the crossed-out wheeled bin
symbol is affixed to this machine, it signifies that this
machine is compliant with the EU directives as well as
other similar end-of-life legislation in effect after August
13, 2005. Therefore, it must be collected separately after
its use is completed and cannot be disposed as unsorted
municipal waste.
The user is responsible for delivering the machine to the
appropriate collection facility, as specified by your local
code.
For additional information regarding applicable local
disposal laws, please contact the municipal waste facility
and/or local authorized Taylor distributor.
Summary of Contents for C709
