32
Models C709 & C717
Operating Procedures
Step 3
Take one of the scraper blades and slip it under the
hook at the front of the beater. Wrap the blade
around the beater following the helix and pushing
the blade down onto the helix as you wrap. At the
back end of the beater, slip the blade under the
hook.
Repeat this step
for the second scraper
blade.
Figure 14
USE EXTREME CAUTION
when handling
the beater assembly. The scraper blades are very
sharp and may cause injury.
Step 4
Holding the beater securely, slide the beater one
third of the way into the freezing cylinder. Looking
into the freezing cylinder, align the hole at the rear of
the beater with the flats on the end of the drive
shaft.
Figure 15
Step 5
Slide the beater the remainder of the way into the
freezing cylinder and over the end of the drive shaft.
The beater should fit snugly, but not so tightly that
the beater cannot be turned slightly to engage the
drive shaft. If the beater slides in too easily with little
or no resistance, there will not be enough force
against the beater to hold the blades in place.
Repeat these steps for the other side of the
C717.
Freezer Door Assembly
The assembly of the C709 freezer door is different
from the C717 freezer door. Please follow the
appropriate instructions for your machine.
Model C709 Freezer Door Assembly
Step 1
Place the door gasket into the groove on the back of
the freezer door. Slide the front bearing over the
baffle rod so the flanged edge is against the door.
DO NOT lubricate the gasket or bearing.
(See Figure 16.)
Figure 16
