6-10
OPERATING PROCEDURES
Models C709 & C717
Operating Procedures
6
Daily Opening Procedures
Before performing the opening procedures, check the
display panel for error messages. Normally, the display is
blank unless an operational fault has occurred. If a fault
is detected, investigate the cause and follow the
instructions on the display before proceeding with the
opening procedures. See "Faults" on page 5-12.
Setting Up
Note:
Make sure your hands are clean and sanitized.
1.
Prepare a small amount of an approved 100 PPM
sanitizing solution (example Kay-5
®
or
Stera-Sheen
®
).
Note:
Use warm water and follow the
manufacturer’s specifications.
2.
Sanitize the air orifice(s), front drip tray, and splash
shield in this solution.
3.
Return to the freezer with a small amount of
sanitizing solution. Dip the door spout brush into the
sanitizing solution and brush clean the door spout(s)
and bottom of the draw valve(s).
Figure 6-35
Note:
To ensure sanitary conditions are maintained,
brush-clean each item for 60 seconds, repeatedly
dipping the brush in sanitizing solution.
4.
Using a clean, sanitized towel, wipe down the freezer
door, front panel, the area around the bottom of the
freezer door, and any other areas with a buildup of
either moisture or food substance. Install the front
drip tray and the splash shield.
5. To resume normal operation, press the Auto key.
When the machine cycles off, the product in the
freezing cylinder will be at serving viscosity.
Figure 6-36
6. Lift the hopper cover(s). Turn the inner feed tube of
each assembled feed tube so the pin rests at the
bottom of the notch of the outer feed tube. Install the
air orifice(s).
Figure 6-37
The control has a feature in the Manager's Menu to
enable or disable the Auto Start feature. When Auto
Start is enabled, the machine automatically exits the
Standby mode and starts the machine in the Auto
mode at a designated time each day.
Note:
This procedure should be performed
15 minutes before serving product.
10491
13407BR
12222
Summary of Contents for C709
