USER INTERFACE
5-3
Models C709 & C717
User Interface
5
Standby Key
The standby feature maintains product temperature
below 40°F (4.4°C) in both the hopper and the freezing
cylinder. This feature is useful during long “
no sale
”
periods to prevent overbeating and product breakdown.
If enabled, the Standby key
can be pressed to
place the machine in the Standby mode. If disabled, the
Standby key is inoperable.
Using sanitized hands, remove the air orifice. Place the
end of the feed tube without the mix delivery hole in its
side into the mix inlet hole. (See “Feed Tube Assembly”
on page 5-4.)
Important!
When the feed tube is in the Standby
position, make sure the level of mix in the hopper is
below the mix delivery hole in the feed tube. Failure to
follow this instruction may result in lower product quality
when normal operation is resumed.
When standby is selected, the Standby key
illuminates, indicating the standby feature has been
activated. In the Standby mode, Wash and Auto functions
are automatically canceled.
To resume normal operation, press the Auto key
.
When the machine cycles off, the product in the freezing
cylinder will be at serving viscosity. Using sanitized
hands, invert the feed tube so the end with the mix
delivery hole in its side is installed in the mix inlet hole.
Install the air orifice. (See “Feed Tube Assembly” on
page 5-4.)
Reset Mechanism
The C709 machine's RESET button is in the service
panel on the left side of the machine. The C717
machine's RESET buttons are in the rear panel of the
machine.
RESET button(s) protect the beater motor(s) from
overloading. Should an overload occur, the reset
mechanism will trip. To properly reset the machine, place
the power switch in the OFF position. Press the RESET
button firmly. Turn the power switch to the ON position.
Press the Wash key
/
and observe the
machine's performance.
DANGER! DO NOT
use metal objects to press
the RESET button. Failure to comply may result in severe
personal injury or death.
If the beater motor is turning properly, press the Wash
key
/
to cancel the cycle. Press the Auto key
to resume normal operation. If the machine shuts
down again, contact your a Taylor service technician.
Adjustable Draw Handle
These machines feature an adjustable draw handle(s) to
provide the best portion control, giving a consistent
quality to your product and controlling costs. The draw
handle(s) should be adjusted to provide a flow rate of
5 oz. to 7-1/2 oz. (142 g to 213 g) of product by weight
per 10 seconds. To
increase
the flow rate, turn the screw
clockwise
. To
decrease
the flow rate, turn the screw
counterclockwise
.
Figure 5-2
101540
Summary of Contents for C709
