OPERATING PROCEDURES
6-3
Models C709 & C717
Operating Procedures
6
Note:
Scraper blades should be replaced every
3 months.
8.
Holding the rear blade on the beater, slide it into the
freezing cylinder halfway. Install the front scraper
blade over the front holding pin. (See Figure 6-8.)
Figure 6-9
9.
Before installing the beater shoes, check the shoes
for any nicks, cracks, or signs of wear. If any defects
are present, replace the beater shoes.
10. If the beater shoes are in good condition, install the
beater shoes. (See Figure 6-10.)
Figure 6-10
11. Slide the beater assembly the rest of the way into the
freezing cylinder.
Make sure the beater assembly is in position over the
driveshaft by turning the beater slightly until the
beater is properly seated. When in position, the
beater will not protrude beyond the front of the
freezing cylinder. (See Figure 6-11.)
Figure 6-11
12.
Repeat steps 1 through 11
for the other side of the
C717.
Freezer Door Assembly
The assembly of the C709 freezer door is different from
the C717 freezer door. Please follow the appropriate
instructions for your machine.
Model C709 Freezer Door Assembly
1. Before assembling the freezer door, check the
following for any nicks, cracks, or signs of wear: the
door bearing, door gasket, draw valve, O-rings, and
all sides of the door assembly, including the inside of
the draw valve bore. Replace any damaged parts.
2. If the parts are in good condition, place the door
gasket into the groove on the back of the freezer
door. Slide the front bearing over the baffle rod so the
flanged edge is against the door.
Do not
lubricate the
gasket or bearing.
Figure 6-12
11531
11532
11533
11287
Summary of Contents for C709
