C713 Operator Training
C713 Operator Training
C713 Operator Training
C713 Operator Training
23
Brush Cleaning
Step 1
Prepare an approved 100 PPM cleaning solution (examples: 2-1/2 gal. [9.5 liters] of Kay-5® or 2
gal. [7.6 liters] of Stera-Sheen®). USE WARM WATER AND FOLLOW THE MANUFACTURER'S
SPECIFICATIONS. Make sure all brushes provided with the freezer are available for brush cleaning.
Step 2
Thoroughly brush clean all disassembled parts in the cleaning solution, making sure all lubricant and
mix film is removed. Be sure to brush all surfaces and holes, especially the holes in the freezer door.
Step 3
Rinse all parts with clean, warm water. Place the parts on a clean, dry surface to air dry overnight.
Step 4
Return to the freezer with a small amount of cleaning solution. Using the black brush, clean the rear
shell bearing at the back of the freezing cylinder.
Repeat these steps on the other side of the machine.
Step 5
Wipe all exterior surfaces of the freezer with a clean, sanitized towel.