Taylor C791, Operator'S Manual

USER INTERFACE

5-3 

087482-M 

User Interface 

 5

5.

When the unit cycles off, place the feed tubes in its 

original position (mix delivery hole end down) and 

install air orifices.

Figure 5-3

Important! 

 The standby mode must not be used instead 

of daily disassembly, cleaning, and sanitizing.

WASH Key

When the WASH key is pressed, the light comes on, 

indicating beater motor operation. The Standby or Auto 

mode must be canceled first to activate the Wash mode.

AUTO Key

When the AUTO key is pressed, the light comes on, 

indicating that the main refrigeration system has been 

activated. In the Auto mode, the wash or standby 

functions are automatically canceled. The mix 

refrigeration function is automatically locked in to 

maintain the temperature of the mix in the mix hopper.

Note:  

An indicating light and an audible tone will sound 

whenever a mode of operation has been pressed. To 

cancel any function, press the key again. The light and 

mode of operation will shut off.

Indicator Light—MIX LOW

Located on the front of the machine is a mix level 

indicating light. When the light is flashing, it indicates that 

the mix hopper has a low supply of mix and should be 

refilled as soon as possible. Always maintain at least 3 in. 

(76 mm) of mix in the hopper. If you neglect to add mix, a 

freeze-up may occur. This will cause eventual damage to 

the beater, blades, drive shaft, and freezer door.

Indicator Light—MIX OUT

When the Mix Out symbol is illuminated, the mix hopper 

has almost completely exhausted and has an insufficient 

supply of mix to operate the freezer. At this time, the Auto 

mode is locked out and the freezer will be placed in the 

Standby mode. To initiate the refrigeration system, add 

mix to the mix hopper and touch the Auto symbol. The 

freezer will automatically begin operation.

RESET Button

The reset button is located on the front of the C791 and 

C794. The reset protects the beater motor from an 

overload condition. If an overload occurs, the reset 

mechanism will trip. To properly reset the freezer:

1. Press the AUTO key to cancel the cycle.

2. Turn the power switch to the OFF position.

CAUTION! DO NOT 

use metal objects to press 

the reset button.

Failure to follow this instruction may 

result in electrocution.

3. Wait two or three minutes and then press the reset 

button firmly.

4. Turn the power switch to the ON position.

5. Press the WASH key and observe the freezer's 

performance. If the beater motor is turning properly, 

press the WASH key to cancel the cycle.

6. Press the AUTO key on both sides of the unit to 

resume normal operation. If the freezer shuts down 

again, contact a Taylor service technician.

30123