6-2
OPERATING PROCEDURES
087482-M
Operating Procedures
6
3.
Insert the drive shafts into the freezing cylinders, hex
end first, and into the rear shell bearings until the
seals fit securely over the rear shell bearings.
Engage the hex ends firmly into the drive couplings.
Be sure the drive shafts fit into the drive couplings
without binding.
Figure 6-2
4.
Take one of the scraper blades and slip it under the
hook at the front of the beater. Wrap the blade
around the beater, following the helix and pushing the
blade down onto the helix as you wrap. At the back
end of the beater, slip the blade under the hook.
Figure 6-3
5.
Repeat step 4 for the second scraper blade.
6.
Repeat step 4 and step 5 for the other beater.
7.
Holding the beater(s) securely, slide the beaters
one-third of the way into the freezing cylinders.
Looking into the freezing cylinders, align the hole at
the rear of the beaters with the flats on the end of the
drive shafts.
8. Slide the beaters the remainder of the way into the
freezing cylinders and over the end of the drive
shafts. The beaters should fit tightly, but not so tightly
that the beaters cannot be turned slightly to engage
the drive shafts. If the beaters slide in too easily with
little or no resistance, there will not be enough force
against the beaters to hold the blades in place. If this
is the case, contact your authorized Taylor service
technician.
Figure 6-4
Note:
Do not lubricate the gasket(s) or the front
bearing(s).
9. Place the large rubber gaskets into the grooves on
the back side of the freezer door.
10. Slide the white plastic front bearings over the baffle
rods onto the bearing hubs, making certain that the
flanged end of the bearing is resting against the
freezer door.
Figure 6-5
11. Slide the two O-rings into the grooves on each prime
plug. Apply an even coat of Taylor Lube to the
O-rings and shafts.
30131_A
11097
Summary of Contents for C791
Page 8: ...1 4 TO THE INSTALLER 087482 M To the Installer 1 ...
Page 38: ...9 2 PARTS REPLACEMENT SCHEDULE 087482 M Parts Replacement Schedule 9 Notes ...
Page 42: ...10 4 LIMITED WARRANTY ON EQUIPMENT 087482 M Limited Warranty on 10 Notes ...
Page 46: ...11 4 LIMITED WARRANTY ON PARTS 087482 M Limited Warranty on Parts 11 Notes ...
