Taylor Frigomat CH02 Series, Instructions And Warnings For Installation And Use

7 - ENGLISH 

3. GENERAL SAFETY STANDARDS 

Strictly comply with the general Safety and Accident-prevention Standards listed hereafter: 

-  Use of the machine is reserved for personnel in good health, responsible and 

appropriately trained regarding allowed use and risks present. 

-  Use of the machine is reserved for operators who have read, understood and taken 

in all that is included in this manual. 

-  It is forbidden to remove or tamper with the safety systems installed on the 

machine. 

-  While the appliance is operating, it is mandatory to check that dangerous situations 

for persons do not occur. Should these conditions transpire, stop the appliance 
immediately. 

-  When you have finished working with the machine, it is mandatory to cut power by 

acting on the master switch. 

-  When unusual noise or anomalous functioning is perceived, it is mandatory to 

immediately stop operations in progress and to search for the cause of these 
irregularities. If in doubt, avoid improper operations by contacting the 
manufacturer's after-sales service. 

-  Any tampering or modification of the machine automatically entails the immediate 

termination of the warranty and relieves the manufacturer of all and any liability for 
direct or indirect damage caused. 

-  It is mandatory to check that the place where the machine is installed is ventilated 

and correctly illuminated. The surface where the appliance is installed must be 
solid, flat and levelled. 

-  During loading, unloading and handling operations, it is mandatory to use 

equipment with a capacity adequate for the mass (weight) of the machine, using 
hoisting devices and accessories with features and state of use suitable for the 
purpose. 

-  Use only TAYLOR original spare parts when performing maintenance. The 

manufacturer will not be held liable for damage caused by use of non-original spare 
parts. Use of non-original spare parts entails automatic termination of the warranty. 

-  It is mandatory to position the machine far away from equipment which emits 

electromagnetic radiation which could cause the circuit boards to malfunction. 

-  If fire-prevention equipment is necessary use types which are compatible with the 

presence of voltage on board. 

-  It is forbidden to wear long and loose apparel, ties, jewellery, scarves or similar 

clothing which could get caught in the moving parts of the machine. 

-  Hair must be tied back and shirt-sleeves tight.