20
Models 8752, 8756, 8757
Operating Procedures
Step 2
Install the drive shaft through the rear shell bearing in
the freezing cylinder and engage the hex end firmly
into the gear box coupling. Be sure the drive shaft fits
into the drive coupling without binding.
Figure 9
USE EXTREME CAUTION
when handling
the beater assembly. The scraper blades are very
sharp and may cause injury.
Step 3
Before installing the beater assembly, look down the
length of the parallel bars of the beater to be sure the
bars are straight with one another. If they are not
straight, the beater is bent and must be replaced.
Check the scraper blades for any signs of wear or
damage. If a scraper blade is nicked or worn, replace
both blades.
Figure 10
Step 4
If the blades are in good condition, place the rear
scraper blade over the rear holding pin on the beater.
Note:
The hole on the scraper blade must fit securely
over the pin to prevent costly damage.
Note:
Scraper blades should be replaced every 3
months.
Step 5
Holding the rear blade on the beater, slide it into the
freezing cylinder half way. Install the front scraper
blade over the front holding pin.
Figure 11
Step 6
Before installing the beater shoes, check the shoes for
any nicks, cracks, or signs of wear. If any defects are
present, replace the beater shoes.
Step 7
If the beater shoes are in good condition, install the
beater shoes.
Figure 12
Step 8
Slide the beater assembly the rest of the way into the
freezing cylinder.
