17
Models 150, 152, 162, 168
Important: To the Operator
Cylinder Temperature Retention
(CTR)
To maintain a good quality product during long “No
Sale” periods, it will be necessary to warm the product
in the freezing cylinder to approximately 35
_
to 40
_
F
(1.7
_
to 4.4
_
C). This will prevent overbeating and
product breakdown. The CTR is used in conjunction
with the SHR to insure that the mix in the freezing
cylinder is refrigerated during the “STANDBY” mode of
operation.
To operate the “STANDBY” mode of operation:
Place the power switch in the “AUTO” position and the
mix refrigeration switch in the “STANDBY” position.
With sanitized hands, remove the feed tube. Turn it
over and place the end without the hole into the mix
inlet hole.
To resume normal operation:
Leave the power switch in the “AUTO” position and
place the mix refrigeration switch in the “AUTO”
position. When the unit cycles off, the product in the
freezing cylinder will be the correct viscosity. With
sanitized hands, remove the feed tube. Turn it over
and place the end with the hole into the mix inlet hole.
