19
Models 150, 152, 162, 168
Operating Procedures
150105
Assembly
MAKE SURE THE POWER SWITCH IS IN
THE “OFF” POSITION.
Failure to follow this
instruction may result in electrocution or injury to
fingers or hands from hazardous moving parts.
Note:
When lubricating parts, use an approved food
grade lubricant (example: Taylor Lube).
Step 1
Lubricate the groove on the beater drive shaft. With the
opening of the cup seal facing away from the hex end,
slide the seal into the groove. Apply an even coat of
lubricant to the seal and the shaft.
Do not
lubricate the hex end of the beater drive shaft.
Figure 15
Step 2
Insert the beater assembly through the rear shell
bearing at the back of the freezing cylinder and engage
the hex end firmly into the female socket. When
properly seated, the beater will not protrude beyond
the front of the freezing cylinder.
Figure 16
Repeat this step
for the second freezing cylinder on
Models 162/168.
Step 3
Place the large o- ring(s) into the groove(s) on the back
of the freezer door and lubricate with Taylor Lube.
Figure 17
Step 4
Slide the front bearing(s) over the baffle rod(s) so the
flanged edge is against the door. Place the white
plastic guide bearing(s) on the end of the baffle rod(s).
Do not lubricate the front bearing(s) or the guide
bearing(s).
Figure 18
Step 5
Slide the slotted portion of the handscrews into the
slots in the freezer door.
Step 6
With both hands, hold the sides of the freezer door and
insert the baffle rod(s) into the center of the beater
assembly(ies). The white guide bearing(s) must fit
securely in the hole(s) of the drive shaft(s).
