21
Models 150, 152, 162, 168
Operating Procedures
150105
Step 11
Insert the valve lifter arm through the slotted opening
in the draw valve and align the other end with the cross
holes of the freezer door.
Step 12
Insert the draw valve handle through the opposite
cross hole and into the opening of the valve lifter arm.
Hint:
The draw valve handle can be assembled at
varied vertical positions. Choose an angle which is
comfortable for you. The draw valve must be raised
completely when the draw valve handle is down.
Figure 24
Note:
For Models 162/168, slide the o- ring onto each
pivot pin and lubricate with Taylor Lube.
Figure 25
Note:
Models 162/168 have three draw handles.
Slide the tip of the draw handle into the slot of the draw
valve, starting from the right. Slide the short pivot pin
through the far right draw handle. Slide the long pivot
pin through the far left and middle draw handles.
Figure 26
Step 13
Snap the design cap(s) over the bottom of the freezer
door spout(s).
Figure 27
Step 14
Install the front drip tray and splash shield under the
freezer door.
Figure 28
