22
Models 150, 152, 162, 168
Operating Procedures
Step 15
Lay the feed tube(s) in the bottom of the mix hopper(s).
Sanitizing
Step 1
Prepare an approved 100 PPM sanitizing solution (ex-
amples: Kay- 5
R
or Stera- Sheen
R
). USE WARM
WATER AND FOLLOW THE MANUFACTURER’S
SPECIFICATIONS.
Step 2
Pour one gallon (3.8 liters) of the sanitizing solution
into the hopper and allow it to flow into the freezing
cylinder.
Step 3
While the solution is flowing into the freezing cylinder,
brush- clean the mix hopper, mix level float stem, mix
inlet hole, and feed tube.
Figure 29
Figure 30
Figure 31
Step 4
Press the reset button.
Figure 32
Step 5
Place the power switch in the “WASH” position. This
will cause the sanitizing solution in the freezing
cylinder to be agitated. Allow it to agitate for five
minutes.
Figure 33
