6
Models C708 & C716
Safety
080826
S
DO NOT
allow untrained personnel to
operate this machine.
S
DO NOT
operate the freezer unless all
service panels and access doors are
restrained with screws.
S
DO NOT
remove any internal operating
parts (example: freezer door, beater,
scraper blades, etc.) unless all control
switches are in the OFF position.
Failure to follow these instructions may result in
severe personal injury from hazardous moving parts.
This unit has many sharp edges that can
cause severe injuries.
S
DO NOT
put objects or fingers in the door
spout. This may contaminate the product
and cause severe personal injury from blade
contact.
S
USE EXTREME CAUTION
when removing
the beater asssembly. The scraper blades
are very sharp.
S
CAUTION-SHARP EDGES:
Two people are
required to handle the cup/cone dispenser.
Protective gloves must be worn and the
mounting holes must NOT be used to lift or
hold the dispenser. Failure to follow this
instruction can result in personal injury to
fingers or equipment damage.
This freezer must be placed on a level
surface. Failure to comply may result in personal
injury or equipment damage.
Cleaning and sanitizing schedules are
governed by your state or local regulatory agencies
and must be followed accordingly. Please refer to
the cleaning section of this manual for the proper
procedure to clean this unit.
DO NOT
obstruct air intake and discharge openings:
C708:
A minimum of 6” (152 mm) air space is
required on both sides and 0” on the rear.
C716:
A minimum of 3” (76 mm) air space is
required on all sides. Install the deflector provided to
prevent recirculation of warm air.
Failure to follow these instructions may cause poor
freezer performance and damage to the machines.
For Indoor Use Only:
This unit is designed to
operate indoors, under normal ambient
temperatures of 70
_
- 75
_
F (21
_
- 24
_
C). The
freezer has successfully performed in high ambient
temperatures of 104
_
(40
_
C) at reduced capacities.
NOISE LEVEL:
Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of
1.0 meter from the surface of the machine and at a
height of 1.6 meters from the floor.
Summary of Contents for Wawa C708
