30
Models C708 & C716
Operating Procedures
USE EXTREME CAUTION
when handling
the beater assembly. The scraper blades are very
sharp and may cause injury.
Step 6
Before installing the beater assembly, check the
scraper blades for any nicks or signs of wear. If any
nicks are present, or if the blades are worn, replace
both blades.
If the blades are in good condition, install the
scraper blade clips over the scraper blades. Place
the rear scraper blade over the rear holding pin on
the beater. (See Figure 17.)
11271
Figure 17
Note:
Scraper blades should be replaced every 3
months.
Note:
The hole on the scraper blade must fit
securely over the pin to prevent costly damage.
Step 7
Holding the rear blade on the beater, slide it into the
freezing cylinder halfway. Install the front scraper
blade over the front holding pin. (See Figure 18.)
11249
Figure 18
Step 8
Install the beater shoes. (See Figure 19.)
Figure 19
Step 9
Slide the beater assembly the rest of the way into
the freezing cylinder.
Make sure the beater assembly is in position over
the drive shaft by turning the beater slightly until the
beater is properly seated. When in position, the
beater will not protrude beyond the front of the
freezing cylinder. (See Figure 20.)
11250
Figure 20
Repeat these steps for the other side of the
Model C716.
Summary of Contents for Wawa C708
