45
Models C708 & C716
Operating Procedures
080617
Brush Cleaning
Step 1
Prepare an approved 100 PPM cleaning solution
(examples: 2-1/2 gal. [9.5 liters] of Kay-5
R
or 2
gal. [7.6 liters] of Stera-Sheen
R
). USE WARM WA-
TER AND FOLLOW THE MANUFACTURER'S
SPECIFICATIONS. Make sure all brushes provided
with the freezer are available for brush cleaning.
Step 2
Thoroughly brush clean all disassembled parts in the
cleaning solution, making sure all lubricant and mix
film is removed. Be sure to brush all surfaces and
holes, especially the holes in the pump components
and the draw valve hole in the freezer door.
Rinse all parts with clean, warm water. Place the
parts on a clean, dry surface to air dry overnight.
Step 3
Return to the freezer with a small amount of
cleaning solution. Using the black brush, clean the
rear shell bearing at the back of the freezing
cylinder. (See Figure 62.)
Figure 62
Step 4
Using the black brush, clean the drive hub opening
in the rear wall of the mix hopper. (See Figure 63.)
Figure 63
Repeat these steps on the other side of the
Model C716.
Step 5
Wipe all exterior surfaces of the freezer with a clean,
sanitized towel.
Summary of Contents for Wawa C708
