LEVERSETS
INSTALLATION INSTRUCTIONS
CONTINUED FROM FRONT PAGE
CUSTOMER SERVICE
WESTERN CANADA
1-800-267-4774 |
EASTERN CANADA
1-800-387-7064 |
USA
1-800-388-9887
taymor.com
® REGISTERED TRADEMARK OF TAYMOR INDUSTRIES LTD.
REV. MAY, 2016
Drill a 1” (25 mm) diameter hole
at the center of the door edge.
1-3/4”
(45 mm)
1-3/8”
(35 mm)
Fold here.
Place on the door edge.
Backset - 2-3/8” (60 mm)
Backset - 2-3/4” (70 mm)
ø
2-1/8” (54 mm)
DOOR PREPARATION TEMPLATE
CHANGE LEVER HANDING
A. Remove the set screw on the side of the lever using the Allen Key.
B.
Swap levers
. Align the hole on the lever with the catch hole on the rose and press until secure.
Reinstall the set screw. Tighten using the long leg of the Allen Key.
EXTERIOR VIEW
LEFT HANDED
SET SCREW & ALLEN KEY (CC & DD)
RIGHT HANDED
✃
USE TEMPLATE PROVIDED TO MARK CENTER HOLES ON THE DOOR
A. Stand so the door swings towards you. Fold the template over door edge
approximately 36” (914 mm) from the floor.
”
CENTERLINE
36” (914 mm) FROM FINISHED FLOOR
BACKSET 2-3/8” (60 mm) - 2-3/4” (70 mm)
)
2-1/8” (54 mm)
CENTERLINE
1” (25 mm)
TEMPLATE
B. Make a center mark for a 1” (25 mm) hole on the door edge and a center mark for a 2-1/8”
(54 mm) hole on the door surface.
C. Drill the 2-1/8” (54 mm) door surface hole. Drill the 1” (25 mm) hole to meet surface hole.
Note: Drill surface hole from both sides to reduce risk of wood splitting.
CARING FOR YOUR LOCK
Our locksets are polished and then protected with a coating to help prevent tarnishing. This protective coating has limitations and in time may deteriorate
from handling, cleaning or exposure to atmospheric conditions such as extreme climate, pollution and proximity to salt water, humidity and ultraviolet rays.
Eventual tarnishing is, therefore, not a defect, but a normal process which is unavoidable. With proper care, these products will last a long time.
To care for your lock, wash and clean only with water and polish with a soft, clean cloth.
1 INCH
IMPORTANT: Print template to scale if not factory supplied instructions.
See other side for lock installation instructions.
LIFETIME MECHANICAL AND FINISH WARRANTY
This product is warranted to be free from finish, mechanical and workmanship defects for the life of the product. Taymor Industries Ltd. will replace
any Taymor Premier series lock which fails to meet this warranty. Any finish deterioration occurring from use of paints, solvents or other chemicals is
not a defect and therefore is not covered by this warranty. Taymor Industries Ltd. is not liable for incidental or consequential damages.
If your Taymor lock does not meet the warranted quality, return the product with proof of purchase information to the Taymor dealer from which the
product was purchased. Go to taymor.com for full warranty information.
NEW DOOR PREPARATION
1
NOTE:
For beveled doors, apply template to pull side of door.
