27/ 42
4
Φ 18.5×13×1.6
oil filter spring
1
5
Outer diameter φ 44×40 cylindrical
oil filter
1
6
ZT1P58MJ oil filter seal ring
1
Can not be missing
Oil filter
Assembly
1. Remove the locking bolt of the oil filter cover with a t-shaped sleeve -10#, and take out the ZT1P58MJ oil filter cover (ceramic
),
φ 18.5×13×1.6
oil filter spring,
φ 51×φ2.65 hydrogenated nitrile rubber
O-ring , cylindrical oil filter
with outer diameter φ 44×40 ,
ZT1P58MJ oil filter sealing ring .
Install
1. During installation, the ZT1P58MJ engine oil filter sealing ring is first inserted into the corresponding position of the oil filter,
and the end of the oil filter with the sealing ring is inserted into the boss at the corresponding position of the left box, and
replaced with a new φ51 ×φ2.65 hydrogenated nitrile rubber o
-type then press the O-ring into the groove of the oil filter cover,
insert the oil filter spring into the boss of the oil filter cover, install the oil filter cover to the corresponding position of the left box,
and screw in 3 non-standard cover-shaped 9-level nuts m6 ×13 , tighten with fixed torque after pre-tightening, torque: 10±1N.m.
Magneto stator, rotor
System components
1
7
6
8
5
10
9
11
3
4
2
6
