Model LR-26C, LR-623, LR-28A, & LR-2355 Hoist Installation and Operation Manual
Stock No. 036268
Page 9 of 27
"INSTALLATION INSTRUCTIONS"
1.
Mark the location for the rear hinge. This location should be immediately behind a truck cross
member, approximately 32" behind the center of the rear axle on single axle trucks. Refer to
Figure 1 and the charts for the specific hoist model you are installing.
NOTE:
If a distance of 38" is exceeded between the rear hinge and the center of the rear axle,
additional reinforcement of the truck frame will be required.
2.
Referring to Figure 2, cut a notch as shown.