Model LR-26C, LR-623, LR-28A, & LR-2355 Hoist Installation and Operation Manual
Stock No. 036268
Page 18 of 27
"INSTALLATION OF BODY PROP"
NOTE:
The following steps are to be used as a guideline when installing the body prop. Since
trucks will vary according to their design it is not possible to be specific about every
aspect of the body prop installation.
1.
Once the TBEI-Rugby hoist has been installed, raise the hoist up and temporarily block the
body up. Position the prop assembly against the truck frame as illustrated in Figure 9.
2.
Fasten the body prop assembly base to the truck frame.
3.
Position and fasten the prop hanger to the truck frame. Hanger must be installed so that when
the body is down the body prop leg will not bounce out of the hanger.
4.
Position and weld the prop cup on the body as illustrated in Figure 10.
NOTE:
To raise and lower body prop, see the
"OPERATION OF BODY PROP"
section of
this manual.
FIGURE 10
