User Manual NVR TBK-NVR5016P8 TBK PLUS
15
www.tbkvision.com
5.2.2 Main Monitor
The main monitor settings allow you to set camera sequence in live display mode.
Operate the following steps to set main monitor:
①
Go to Main Menu
Setup
Live
Main Monitor interface. Refer to Fig 5-7.
②
Select display mode and channel.
③
Select dwell time. Click
button to set up the dwell time of the previous channel. Click
button to set the dwell time of the latter
channel groups.
④
Click “Apply” to save the setting.
Fig 5-7 Live Configuration-Main Monitor
5.2.3 Mask
If there is something you don’t want to display in the live image. You can set mask. For a given channel a maximum of three areas can be
masked. If the mask function is not available in the added IP camera, the mask function here will not take effect.
To set up mask area:
①
Go to Main Menu
Setup
Live
Mask interface.
Fig 5-8 Live Configuration-Mask
②
Click “Setting” button to go to live image.
③
Press and drag the left mouse button to set mask area as shown below.
④
Right click to exit the mask setting interface.
⑤
Click “Apply” button to save the setting.
To delete mask area:
①
Click “Setting” button in the mask interface.
②
Select a certain masked area and double click to delete that masked area.
③
Then click “Apply” button to save the setting.
Fig 5-9 Setting Mask Area
