- 4 -
3
GeneralNotes
The MPL024 is designed for use with Video Monitors and other analogue signal input
displays. Here are some notes for correct use:
•
Power Input:
12V DC, 1.2A (minimum) is required; this should be a regulated supply.
•
Digital Video -
use MPEG-1/2* video encoded at Video-CD standard. (See “Content
Creation Guide” for proper encoding rate.)
* For MPEG-2 video, the encoding rate is limited to 5Mb/s (in normal CF card)
•
Audio & Video output -
Video - displays PAL & NTSC signals with either Composite,
S-video or Component signal. The PAL/NTSC switch should be set correctly. Audio -
Stereo output. Volume is controlled by the switch mount buttons.
•
Remote Ext.
- Using the standard switch mount (p/n: 4161013-00) - 8 momentary
buttons for OSD config and video playback control (standard functions (in simple play
mode) being : Play, Stop, Pause, Next Track, Volume decrease, Volume increase,
Mute). An optional function control device is a custom-made switch mount connected
to the switches and buttons connectors(CN6 and CN3) with a maximum of 16
momentary buttons
•
Remote Ext. cable -
The cables (p/n: 4266318-00) to the switches and buttons
connector should be of suitable quality and length so that impedance does not affect
performance. Generally lengths up to 1 meter (3 feet) should be acceptable.
•
LED (LED1) -
The power LED indicator shows power is being supplied to the
MPL024. The Status LED indicates the status of CF card.
•
COM port
– Requires DB-9 extend cable for RS-232 connection. This
serial port only
supports barcode scanner.
•
USB –
USB Host. Use USB memory stick for content update without removing the CF
card.
•
VGA out –
Supports
VGA resolution 640x480.
•
Service & Warranty:
Warranty is invalidated if the unit is dismantled in any way. The
unit is not user serviceable or repairable.
CAUTION:
Do not attempt to remove any part of the casing or internal parts.
