-
We recommend a package of servo wire holders
-
Landing gear and tailwheel. TBM has these specially made for the P-40.
-
Fuel overflow bulkhead type fitting
-
Batteries – one for ignition and two for Rx are recommended. Three 2600 mah batteries will offer 10
flights. You may need regulators.
-
Switches for the Rx and ignition.
-
A few feet of fuel line
-
Loctite!
ASSEMBLY SEQUENCE
PLEASE FOLLOW THE ORDER AS FOLLOWS FOR THE EASIEST INSTALLATION
QUICK OVERVIEW
1)
Rx, switches and temporarily mount a battery.
2)
Rudder and tailwheel
3)
Engine
4)
Muffler
5)
Throttle and Choke servos
6)
Fuel tank
7)
Landing gear
8)
Wing servos
9)
Stabs
10)
Cowl
11)
Canopy
12)
Spinner
13)
Batteries
1)
In order to set up your servos and retract valve, you need the Rx, switch(s) and battery installed. Put
them where shown in the photos below. Later you should mount the 2 Rx batteries where necessary for
balance.
