(C) TBProAudio 2016
Page 5 of 8
5 Plugin Controls
5.1 Pre-Filter
Filters the signal for loudness measurement. This let the loudness measurement focus on the
specific frequency range e.g. vocals or bass.
Low/High-Cut Filter:
1 - 22k Hz
5.2 Input Control
Side chain
GainRider 2 can use side-chain (VST3/RTAS/AAX/AU) or channel 3+4 (VST2) as control
channel for the ride process.
Input Mode:
•
INT (Internal): main signal is leveled towards target level. The blue curve shows the
incoming signal, the red curve the outgoing signal.
•
SC1 (Side Chain 1): The main signal is leveled to target level as soon control signal is
above noise level. This process is called ducking. The blue curve shows the control
signal, the red curve the outgoing signal.
•
SC2 (Side Chain 2): The main signal is leveled towards control signal as soon main
signal is above noise level. The blue curve shows the control signal, the red curve the
outgoing signal.
Target Level (dBFS):
Sets the target loudness for the main signal (mode INT) or the control signal (mode SC1)
