Quick Start Guide - BNF set
The following steps will get you setup and ready to fly quickly. It is a condensed version intended for
experienced pilots/builders. Each step is elaborated in more detail in this manual if you are new to this.
You will need to charge and mount the battery, bind the R/C receiver, configure the flight control, and
potentially adjust VTX channel.
This section requires the following equipment.
●
Depending on the version you have, 5-channel Spektrum, FrSky or Futaba S-FHSS R/C radio
transmitter with one of the supported protocols (Check page 3)
●
5.8 GHz FPV receiver system/display/goggles
●
BetaFlight
on a computer (PC/Mac) for detailed configuration
Let’s go!
1. Charge the battery with the supplied JST adapter cable on 1C/600mA rate using a LiPo charger
2. On the radio, hold the bind-button while powering on the transmitter
3. Plug in the battery on the frame and within 10 seconds the Spektrum receiver should bind to the
transmitter, the red LED should stop flashing
4. On the radio change the end-points for all channels to 130%, if needed, to reach the approx. range of
1050 to 1950, connect to
BetaFlight
(
SiLABS VCP drivers
) and check under the “Transmitter”-tab to
verify
5. Next, to set the video transmitter channel and power setting, hold the menu button for 3 seconds
and use the table later in the manual to change the settings
6. Lastly, power on your vrx/goggle/display (default channel 5860 MHz) and spin up by holding throttle
down-right (mode 2) and turn off by holding throttle down-left or turning off the radio (failsafe)
6
