www.tbs-technology.de
6
Normal Mode (Mode 1)
At the very beginning, you need to create a configuration file under the Linux system
directory:
/etc/modprobe.d/mxl58x.conf
.
The contents of the configuration file:
options mxl58x mode = 1
.
After completing the configuration, restart your computer please.
In normal mode: You can watch TV channels from high frequency/low-frequency noise
V/H TV signals search through all four interfaces "Input 0, Input 1, Input 2, Input 3".
Connecting to a satellite cable:
Input 0: Only works for tuner 0 and tuner 1
Input 1: Only works for tuner 2 and tuner 3
Input 2: Only works for tuner 4 and tuner 5
Input 3: Only works for tuner 6 and tuner 7
Hint:
If you want to receive full TV channels from V/H satellite signals at the same time, you
need to connect more than 2 satellite TV signal cables to the corresponding input
interface.
For example, connect the satellite cable to the Input 0 and Input 1 interface, and you
can then simultaneously search for TV channels from the V/H satellite TV signal.
In normal mode:
Input 0 (corresponds to Tuner 0 or Tuner 1) can only use V or H if the corresponding
signal is sent to it.
However, it is not possible to use V with Tuner 0 and at the same time to use Tuner 1
H.
Summary of Contents for Octa-Tuner TBS-6909
