Operation – Rear Panel
BH550 / BH800 English Manual (2014-10-01) 15
This section describes the rear panel ports and controls of your bass amp from left to right.
The descriptions apply to both BH550 and BH800 – the only difference between these amps is their power.
9
10
11
12
13
14
15
16
17
9.
MAINS IN – Power
switch & Power input
The switched-mode power supply of this de-
vice accepts voltages from 100 V to 240 V. The
ground pin of the power supply unit must always
be connected in order to avoid voltage differ-
ences between e.g. the PA and your bass amp.
10.
SPEAKER OUT jack
Use the SPEAKER OUT connector for connect-
ing your amp to speaker cabinets.
Please note that this is a speakON connector,
and you must use speaker cables for connect-
ing the amp to your cabinets. Do not use instru-
ment cables!
Use a cabinet configuration with your BH550/
BH800 with a minimum load of 4 Ohms.
11.
PEDAL input jack
You can connect a TC Electronic Switch-3 to the
PEDAL input of your bass amp to control the fol-
lowing features:
►
Mute on/off
►
Switch currently selected TonePrint effect on
or off
►
Toggle between TonePrint slots 1 and 2.
For more information about Switch-3, see
tcelectronic.com/switch-3/
Summary of Contents for BH550
