DVR2
/
9
EE
NN
GG
LL
II
SS
HH
Pre Delay
Range: 0-500ms (Vintage values: 0, 20, 40 and 60ms)
Pre delay is the amount of time from an input is received until reverb starts building
up at the output.
VINTAGE
Modulation
Range: 0% – 200% (default: 100%)
Sets the Depth of the modulation. Normal set to 100%. Increase if you like a more
liquid, chorus like sound.
Hi Cut
Range: 8kHz – 13kHz (default: 11kHz)
This is DVR2´s HiCut and can be used to limit or extend the overall frequency spec-
trum.
Q Scale
Range: 0.3 – 1.4 (default: 1.2)
Corresponds the small potmeters inside older reverbs used to equalize sound differ-
ences caused by electric component-tolerances. Use the Q-scale in combination with
the HiCut Frequency to shape the treble to your personal flavor.
Input Trans
Range: on/off (default: off)
Emulates the sound of Input transformers typically used in vintage Reverbs. Use it to
create a warm vintage like sound. Especially good for short Decay times.
Trim Lo Freq
Range: on/off (default: on)
A subtle damping of selected frequencies in the lower end.
Lo Res
Range: on/off (default: on)
Switches the DVR2 to a lower bit-resolution. This adds an older and more grainy
sound and also noise giving a simulation of various vintage reverbs.
Vintage Reset
Clicking on this button will reset the controls in the “Vintage” section back to the val-
ues as they are found on the vintage original.
Summary of Contents for Digital Vintage Reverb DVR2
Page 1: ...MANUAL...