TC Electronic DITTO X2 LOOPER, English Manual

 Setup

Ditto X2 Looper English Manual 4

Setup

Ready…

The Ditto X2 Looper box should contain the fol-
lowing items:

– 1 

Ditto X2 Looper pedal

– 2 

rubber feet

 for “non-velcro” pedalboard 

mounting

– 1 

USB cable

 (for transferring loops from and 

to a computer and for updating the pedal 
firmware)

– 1 

“Quick Start Guide”

 sheet

– 1 

TC Electronic sticker

–  1 leaflet about TC’s guitar FX product range

Inspect all items for signs of transit damage. In 
the unlikely event of transit damage, inform the 
carrier and supplier.

If damage has occurred, keep all packaging as it 
can be used as evidence of excessive handling 
force.

Set…

–  Connect a 9V power supply delivering a mini-

mum of 100 mA with the following symbol to 
the DC input socket of Ditto X2 Looper.

!  Please note that Ditto X2 Looper does not 

come with a power supply.

–  Plug the power supply into a power outlet.
–  Alternatively, you can operate Ditto X2 Looper 

using one or two 9V batteries.

  Ditto X2 Looper has two battery slots. You 

can operate the pedal using only one battery, 
but using two batteries will prolong operation 
time.

–  Connect your instrument to the MONO input 

jack on the rear of the pedal using a ¼“ jack 
cable. You can also feed the pedal with a ste-
reo signal by using both INPUT jacks.

–  Connect the MONO output jack on the rear 

of the pedal to your amplifier using a ¼“ jack 
cable. You can also send a stereo signal from 
the pedal to the next device in the signal chain 
by using both OUTPUT jacks.

  For more complex setups, see “Setup exam-

ples” on page 5.

Let’s get loopin’!

If you are in a hurry, chances are you’ll find what 
you’re looking for in this overview.

Operation

Power up  
Ditto X2 Looper

Connect a power supply or in-
sert a battery.

Record

Tap the LOOP footswitch 
once.

Switch to  
playback

Tap the LOOP footswitch 
again.

Undo / Redo  last 
recording

Press and hold the LOOP foot-
switch.

Stop

Double-tap the LOOP foot-
switch 

or

Tap the FX footswitch (FX se-
lector has to be set to “Stop”)

Stop & clear the 
loop

Double-tap and hold the LOOP 
footswitch 

or

Tap and hold the FX footswitch 
(FX selector has to be set to 
“Stop”)

Resume  
playback

Tap the LOOP footswitch 
again.

Engage  
Reverse effect

Tap the FX footswitch  
(FX selector has to be set to 
“Reverse”)

Engage  
½ Speed effect

Tap the FX footswitch  
(FX selector has to be set to 
“½ Speed”)