Inputs, outputs and controls
Flashback Triple Delay English manual 2014-10-14
23
Storing presets
When you have changed the settings for one of
the three Delay Engines (e.g. its delay time), you
may want to store your settings as a preset. You
can store the settings for each Delay Engine in-
dividually using its footswitch.
To store the setting for a Delay Engine (1, 2 or 3),
press and hold its footswitch for circa two sec-
onds.
The footswitch LED will blink green to confirm
that the preset has been stored. Storing will mute
the delay output for about one second.
Delay spill-over
The pedal has two bypass modes: True Bypass
and Buffered Bypass. Changing the bypass
mode is described under “Switching the pedal
from true bypass to buffered bypass mode”.
When the pedal is set to True Bypass and you
switch off the currently selected preset, the de-
lay will immediately be switched off.
When the pedal is set to Buffered Bypass and
you switch off the currently selected preset, the
delay will be allowed to fade/“ring out”.
Preset content
A preset includes all settings of the delay mod-
ule – including the currently used TonePrint (i.e.,
if the Delay type selector is set to one of the four
TonePrint slots).
If you have attached an external expression ped-
al, the parameters assigned to this expression
pedal are stored as part of the preset as well.
Summary of Contents for Flashback Triple Delay
