TC1280 STEREO DIGITAL AUDIO DELAY OWNERS MANUAL Rev. 2.1, Software version 2.04
Page 4 of 9
PRESETS
The TC 1280 has 4 presets. Just make your delay setting, and these values will remain as a
preset until changed. Select another preset number (UTILITY PARAMETER 6, VALUE 1 - 4)
and adjust the delay time. Both are now selectable by recalling the appropriate preset number
by MIDI or by remote.
Note: The preset no. received on the MIDI IN is passed to the MIDI OUT on the same channel.
Thus allowing daisy chaining of several TC1280s, TC1380s and other MIDI equipment.
MIDI
Set the UTILITY PARAMETER 2 to the appropriate MIDI channel / device number. Recall the
desired preset by MIDI program change command.
The bypass status of the TC1280 can be set with MIDI Controller #0: value 0-63 = BYPASS,
value 64-127 = active.
MIDI SYSEX documentation is available on request. Please contact your local TC distributor.
REMOTE
By using the remote facility on the rear panel the TC 1280 can change presets and bypass
status with the TC 0050 remote pedal
(Note: The TC0050 have been discontinued).
The TC0050 schematic is found below:
Note: The preset no. selected with the remote is sent as MIDI program change command to the
MIDI OUT. Thus, several TC1280s, TC1380s and other MIDI equipment can be remotely
controlled by one TC0050.
