TC-Helicon PERFORM-VE, User Manual

8

PERFORM-VE User Manual

SET + Preset 3: Mic Control

RED

: Mic Control Off

Use this when you have a condenser microphone. If you have another Mic Control 

mode set, you may inadvertently activate buttons on the box as you sing.

GREEN

: MP-75 Mode

YELLOW

: MP-76

Mode

The MP-75 and MP-76 buttons can be reassigned to control the following:

• 

DOUBLE

• 

MORPH

• 

HARDTUNE

• 

XFX

• 

ECHO

• 

FILTER

• 

LOOPER Record/Play/Erase

• 

SAMPLE record

• 

SAMPLE play

• 

Preset 1

• 

Preset 2

• 

Preset 3

• 

Tap Tempo

SET + Double: MIDI SYSEX Dump Current Preset

Holding down the SET button and pressing the DOUBLE button outputs the sysex 

of the current active preset parameters.

SET + Tap

Holding down the SET button and pressing the Tap button toggles drum 

quantizing on and off.

SET + Kick:

 Erase Kick loop component

SET + Snare:

 Erase Snare loop component

SET + Headphone:

 Erase Hi-hat loop component

SET + Loop:

 Erase Audio loop component

4.2  The Headphone Button

When the looper button is lit or pulsing, the headphone button plays the hi-hat. 

The loop needs to be erased to be able to adjust the headphone level.
Now that the basics are out of the way, let’s check out Perform-VE’s effects!

Holding down the SET button and pressing 

Preset 3 repeatedly will cycle through Mic 

Control settings, with the VU meter LED showing 

which mode you’re in.

On your TC-Helicon MP-75 Microphone, the single 

Mic Control button cycles the preset selection. You 

can reassign the Mic Control button by holding the 

button and then pressing the corresponding button on 

Perform-VE that you’d like to control. 

For example, if you hold the Mic Control then press the 

Reverb button, the MP-75 will now toggle Reverb on 

and off. 

In MP-76 mode, the Mic Control button cycles the preset 

selection as it does in MP-75 mode.  The remaining three 

buttons default to toggle the following effects on your 

Perform-VE:

• 

Left

 toggles ECHO.

• 

Right

 toggles FILTER.

• 

Bottom

 toggles XFX.

NOTE: If you have a TC-Helicon MP-76 connected but 

choose MP-75 mode instead, the lower three buttons will 

not operate.

When held down, 

HEADPHONE Level

adjusts the volume of 

the headphone jack. 

Range: -60 to 0 dB