TMN-10 User Manual V1.1 (for Administrator)
5
4.2 How to Configure Subnode
Step 1
Configure all the subnode ID (refer to section 3.1 Subnode ID)
Step 2: Connect all the subnodes to the TMAS Master (TMN-5000). Refer to Appendix A for the
hardware connection.
Step 3
Use PC Manager to configure the TMAS Master (TMN-5000). Please refer to PC Manager
manual for setting.
Note: Once the subnode is configured successfully, its Power LED will blink every time the TMAS
Master polls it. The polling sequence is going in a loop from subnode 0, subnode 1, subnode 2,
until the last subnode and return to subnode 0 again. Thus if the blinking is going in a smooth
loop, the subnodes are working fine.
