ANL - ANLH 020-202
Standards applied in the DESIGN and
MANUFACTURE of the unit:
SAFETY
1. Machinery directive 2006/42/CE
2. Low voltage directive LVD 2006/95/CE
3. Electromagnetic compatibility directive
EMC 2004/108/CE
4. Pressure vessel directive PED 97/23/CE,
EN 378,
5. UNI12735, UNI14276
ELECTRICAL
1. IEC EN 60335-2-40,
2. IEC EN 61000-6-1/2/3/4
ACOUSTICAL
1. ISO DIS 9614/2
(intensity method)
PROTECTIVE RATING
IP24
CERTIFICATION
EUROVENT
UNI EN 14511:2011
REFRIGERANT
This unit contains fl uoride gases with greenhouse effect
covered by the Kyoto Protocol. Maintenance and dis-
posal must only be carried out by qualifi ed staff, in
accordance with local regulations
WARNING
1. The refrigerant circuit is under pressure. Additionally,
high temperatures can be generated. The unit can only
be worked on by a TAS technical assistance operative
or a qualifi ed technician. Interventions on the refrige-
rant circuit can only be carried out by a qualifi ed refri-
geration technician.
2. GAS R410A
The units are delivered with their operating charges of
refrigerant R410A. This is a refrigerant without chlorine
which does not damage the ozone layer. R410A is
not fl ammable. All maintenance procedures must be ca-
rried out by a qualifi ed technician with the appropriate
safety equipment.
3. Danger of electrical shock!
Completely disconnect the unit from the power supply
before starting procedures.
1. GENERAL INSTRUCTIONS FOR THE INSTALLER
The AERMEC ANL units are manufactured in accordance
with recognised technical and safety standards.
They are designed for air conditioning and production of
domestic hot water (DHW) and must be used in a manner
compatible with their performance characteristics.
All contractual and extra-contractual liabilities causing da-
mage to persons, animals or objects or through errors of
installation, control or maintenance or from improper use
are excluded by the Company.
Any uses not expressly indicated in this manual are not
permitted.
1.1. CONSERVATION OF DOCUMENTATION
1. Submit the manual with all supplementary documen-
tation to the system user who will be responsible for
the conservation of documents so that they can be
available when needed.
2. Read this manual fully: all works must be carried
out by qualifi ed personnel, in accordance with any
applicable current local regulations.
3. The unit must be installed in a manner to render possi-
ble maintenance and/or repair operations.
4. The equipment warranty does not cover any costs as-
sociated with lifting or access equipment necessary
for warranty procedures.
5. Do not modify or tamper with the equipment as this
could result in accidents for which the manufacturer will
not be held responsible. The warranty will be voided
if the above mentioned warnings are not respected.
1.2. SAFETY INSTRUCTIONS AND INSTALLATION
STANDARDS
1. The equipment must be installed by a competent and
qualifi ed technician, in compliance with the applica-
ble national legislation of the country of destination.
AERMEC assumes no responsibility for any losses in-
curred by not observing these instructions.
2. Before commencing any works it is necessary to
CA-
REFULLY READ THE INSTRUCTIONS AND MINIMI-
SE ANY RISKS BY TAKING APPROPRIATE SAFETY
PRECAUTIONS.
All relevant personnel must be made
aware of the procedures and possible risks that may
arise at the time of installation of the unit.
4
1. GENERAL INSTRUCTIONS FOR THE INSTALLER
