24
Listening to the radio
Slide the On/Off switch on the back of the device to
ON
.
1.
Press the volume dial, several times if necessary, until a frequency
2.
and
FM
are shown on the display.
In radio mode, the set frequency fades and is replaced by the current time.
Configuring and saving radio stations
You can read the set frequency on the display.
Automatic station scanning with automatic station memory
Start an automatic station scan by pressing and holding
m
for approx. 2 seconds.
The device scans frequencies for stations and stores these in the
memory locations
P-01
to
P-20
. Stations previously stored at that
location are overwritten.
Once the scan is complete, the device switches to memory location
P-01
.
Automatic station scanning and manually storing stations
Start an automatic station scan by pressing and holding either
1.
(scan upwards) or
(scan downwards) for approx.
2 seconds.
The scan stops as soon as a station is located.
2.
To save this station, press
for approx. 2 seconds until
3.
P-01
flashes on the display.
Briefly press
to save the station. Stations previously
4.
stored at that location are overwritten.
/ AUTO SCAN
/ SCAN+
/ SCAN-
/ PRESET
/ PRESET
• If you wish to save stations manually, the device will first suggest
memory location
P-01
, even if a station has already been auto-
matically stored to this location.
• If all memory locations are occupied, memory location
P-01
is once again suggested and overwritten if necessary.
Fine-tuning the station frequency
Fine-tuning of the station frequency can be done in 0.5 MHz steps.
Briefly press
or
to adjust the frequency up
m
or down.
If a station cannot be received clearly (too much static), try
adjusting the position of the antenna.
Calling up saved stations
Press the
button.
1.
The current memory location will be displayed for a few seconds.
While it is being displayed, press
or
to call up
2.
another memory location.
/ PRESET
/ SCAN+
/ SCAN-
/ SCAN+
/ SCAN-
24
83641 en Smartphone_Dockingstation_v5 09.12.15 10:57 Seite 24
