16
3. As soon as the coffee starts
being dispensed,
press and
hold
the coffee button.
4. Release the button as soon as
the desired quantity has been
dispensed into the cup.
The setting is saved and two beeps will sound in confirmation.
If the settings are not to your taste, simply repeat the procedure to change
them again.
Restoring the factory settings
You can restore the original settings for the water quantity.
1. Press the On/Off button
to switch the machine on.
2. Wait until the machine heats
up and all buttons light up
continuously.
3. Press and hold the On/Off
button and the “Intense
+
”
button for approx. 5 seconds
until you hear 2 beeps.
4. Release the buttons.
The factory settings for the water quantity have been restored
Customising the automatic rinse
The default setting of the machine is for the automatic rinse to only start when
the machine is cold. If the machine was used shortly before it is switched on, and
is thus still warm, the rinsing process will not restart. A new rinsing process will
only start once the machine has cooled down sufficiently.
You can customise the rinsing process so that it starts every time you switch
on the machine:
1. Press the On/Off button to switch
on the machine.
2. Wait for the machine to warm
up and for all buttons to light
up continuously.
3. Press and hold the On/Off button
and the hot water button for
approx. 5 seconds until you hear
2 beeps.
4. Release the buttons.
The automatic rinse will now start every time you switch on the machine.
Proceed in the same way to revert to the original, temperature-sensitive
settings.
m
