49
14. Press the
On/Off
button
to switch on the machine.
The
EasyClean
button flashes
and the heating up process
starts.
WARNING
risk of scalds/burns
Hot water, hot coffee or hot milk froth from the coffee or milk spout
can cause burns.
• Do not touch the coffee or milk spout during or immediately after use.
Avoid coming into contact with the beverage coming out of the spout.
The pump starts after a few seconds. A small amount of water is firstly
flushed through the milk spout and then through the coffee spout and
into the drip tray.
15. Pour out the water in the
drip tray if necessary.
The machine is ready for use.
Switching the machine on
Requirements:
• The mains plug is plugged into the socket.
• The machine is switched off.
• The water tank is full.
• The coffee bean compartment is full.
To switch on the machine, proceed as follows:
Press the
On/Off
button
to switch on the machine.
The
EasyClean
button flashes
and the heating up process
starts.
The pump starts after a few seconds. A small amount of water
is flushed through the system and dispensed into the drip tray.
The machine is ready for use
as soon as all the buttons
are lit up continuously.
If the machine is still warm from recent previous use, flushing will
not be performed again when it is switched on. A new flushing
process will only be triggered when the machine has sufficiently
cooled down. See chapter “Adjusting the automatic flushing
process“.
en
106466 en Esperto_Pro_v5.indd 49
14.06.21 12:24