20
4. Fill coffee beans into the coffee
bean compartment.
5. Place the lid back on the expan-
sion. Press the lid all the way on
so that the aroma protection seal
can optimally protect the aroma
of the coffee beans.
Adjusting the automatic rinsing cycle
At the factory, the machine is preset that the automatic rinsing cycle only starts
when the machine is cold. If the machine was already in operation shortly before
being switched on and is therefore still warm, the machine will not rinse again.
Only after it has cooled down sufficiently, a new rinse cycle is initiated.
You can adjust the rinse cycle so that it takes place automatically each time the
machine is switched on again:
Prerequisite:
• The machine is switched on and ready for operation.
1. Press and hold both the on/off
switch and the rinsing button for
approx. 5 seconds until
2 beeps sound.
2. Release the buttons.
The automatic rinse cycle now takes place each time the machine is switched on
again.
To restore the original, temperature-dependent state, proceed in the same
way.
109547 en Kaffeevollautomat_USA_v4.indd 20
109547 en Kaffeevollautomat_USA_v4.indd 20
31.08.22 09:49
31.08.22 09:49