15
The rinsing phase will begin.
The middle beverage button will
go out and the indicator light will
flash yellow.
The procedure takes
approx. 2 minutes.
14. Approx. 600 ml of water will be rinsed through the system. Keep an eye on
the container and empty it before it overflows.
15. The machine automatically switches to standby once it is finished.
The indicator light goes out. The descaling process is complete.
Problems / solutions
The indicator light
is flashing red and
there are several
beeping sounds.
Is the water tank empty?
Fill the water tank with fresh water.
m
Press one of the beverage buttons. The pump starts
m
to operate. As soon as the pipes are filled with water,
the pump stops automatically. When the beverage
buttons remain permanently lit, the machine is ready
for use again.
There are coffee
grounds in the cup.
A small residue of coffee grounds always remains at the
bottom of the cup. This is a feature of the system and is
not a fault.
The beverage is not
hot enough.
Especially in the case of espresso, the quantity is so small
compared to the size of the cup that it cools down quickly.
Preheat the cup by filling it with hot water and pouring it
away shortly before using the cup.
Water is dripping
out of the spout.
The water in the system expands as the machine heats up
and, as a result, a little water drips out of the spout.
The indicator light
stays yellow.
The machine needs to be descaled.
Do this within the next couple of days. Do not wait any
longer, otherwise so much limescale may collect that
a descaling agent will no longer have any effect.
A self-induced defect of this kind will not be covered by
the warranty.
Proceed as described in the “Descaling”section.
It is not possible to
press down the
lever.
Check whether the used capsule container is full.
Empty it if necessary.
If a capsule is trapped in the capsule opening, fold the
lever back completely and press the capsule through from
the top to the bottom. Do not reinsert a capsule if it is
deformed!
The rinsing phase
does not finish;
the water tank is
empty, the indicator
light is flashing red
and the machine is
beeping.
Fill the water tank with cold tap water
up to the MAX
mark
and reinsert the tank into the machine. Continue
with step 12 in the chapter “Descaling”, section “Rinsing
phase”.
